LOAD-CENTERS

 

 

Power for ballasts and other peripheral equipment requires a load-center to supply power and breaker protection. Single phase and three phase load-centers are available. The load-center contains contactors or solid state relays. These can be controlled with a timer, PLC, or shutdown device. All load-centers are built to balance all loads across the 240/120V mains power. With ballasts wired for 240V, this makes it  easier. Load-centers are available up to 200 Amps. Smaller load-centers for four to eight ballasts, can be built with a 30A or 50A dryer/range plug. All other load-centers offer only a six-foot power cord and plug. Power cords are available up to fifty feet with a NEMA L15-30 or L15-50 plug. If you require a three-phase load-center, this becomes a “special order”. Three phase load-centers are recommended to have digital Ammeters installed. This allows continuous monitoring of the Amperage draw on each of the three phases with a digital display. Loadcenters are built using only Siemens or Cutler-Hammer breakers and panels.

 

*Please Note*

 

Always have a qualified and licensed electrician install your equipment. If any equipment built by NWN is not installed by a licensed electrician, any applied warranty is voided and NWN is not responsible for any problems that originate from improper installation.

 

info@nowirenuts.ca

 

info@nowirenuts.ca